(solved)Course Work Assignment.. . . . .
Capacitive Circuits in MultisimThis weeks lab is based on the application of circuit analysis techniques to a capacitive circuit in Multisim.Watch the video lecture entitled Week 3 – Capacitor Op-Amp Circuit in Multisim.Construct Figure 7.36 in Chapter 7 (Example 7.11) with Vs = 3sin200tV, R1=20kohms, Cf=5uF, and Vc(0) = 1.5 and find the output voltage Vout.Interchange the positions of the capacitor and resistor and compute the output voltage Vout and record the values in the table below.Construct Figure 7.36 from Chapter 7 in Multisim.Use the function generator to provide Vs to the circuit and run simulation to measure the Vout using Oscilloscope. (Use 5% tolerances for the resistor)Interchange the positions of the resistor and capacitor and run the simulation to record the measurements of Vout in the table above. (Use 5% tolerances for each of the resistors)Take the screen capture for the measurements for Vout.Answer the following questions:Are the measured values same as calculated values? If not, explain why they are different?What type of a circuit does Figure 7.36 represent? Provide a practical use of this kind of Op Amp Circuits.When you interchange the resistor and capacitor, what type of a circuit is obtained? Provide a practical use of this kind of Op Amp Circuits.Use the results obtained from Vout to explain the differences in these two circuits.
Expert Answer
Answer to Course Work Assignment. . . .
OR